Wet cleaning of Ta-based extreme ultraviolet photomasks at room temperature

<!-- START_ABSTRACT --> <p> Owing to the wavelength-dependent limits of the deep ultraviolet exposure process, the semiconductor industry introduced extreme ultraviolet (EUV) lithography operating at a 13.5 nm wavelength. Traditional photomasks employ pellicles for protection; however, EUV-specific pellicles are not widely applicable to commercial processes, requiring the development of a EUV photomask cleaning method. In this study, a wet cleaning method for Ta-based EUV photomasks at room temperature was systematically examined in terms of key parameters, including the pattern step height, surface topography, and particulate count, via atomic force microscopy and x-ray reflectivity. Post sulfuric acid-hydrogen peroxide mixture (SPM) treatment, the photomask exhibited a stable step height, indicating minimal pattern degradation. Additionally, discernible alterations in the surface roughness and a decrease in particle count were observed, further indicating to the effectiveness of SPM-mediated cleaning. Conversely, following standard clean-1 (SC-1) treatment, while the pattern step height remained relatively unchanged, a notable increase in surface irregularities and macroscopic particulates was observed, suggesting a suboptimal cleaning efficiency of the SC-1 solution despite its potential for pattern structure preservation. Our room temperature wet cleaning method efficiently reduces wear-out and successfully eliminates contaminants, potentially prolonging the EUV photomask’s productivity and durability. </p> <!-- END_ABSTRACT --> <!-- START_TEMPLATE --> <ul> <li> Source: </li> <li> Tags: </li> </ul> <!-- END_TEMPLATE -->